Built-in stainless steel wall oven with a microwave above it in a modern condo kitchen, with a technician's toolbox and multimeter on the floor

Wall ovens & ranges · Leduc, AB

Oven Repair in Leduc

Oven not heating, burning the bottom of every tray, or flashing an error code? We fix gas and electric ovens in Leduc homes, most on the same day, and cover each repair for 90 days on parts and labour.

Open 7 days · 7 AM – 11 PM · No weekend surcharge

Oven Faults We Diagnose and Fix

Almost every oven failure traces back to a heating part, an igniter, a sensor or the control. These are the symptoms we get called for most, and what is usually behind them.

Electric oven won't heat

A bake element that has blistered or split, or a thermal fuse that tripped after overheating.

Gas oven stays cold

A worn hot-surface igniter that glows but never gets hot enough to open the gas valve.

Temperature is off

A temperature sensor reading out of spec, so the oven runs well above or below the setting.

Uneven baking

A dead convection fan motor or a broil element that no longer cycles, leaving hot and cold spots.

Broiler not working

A failed broil element, loose wiring at its terminals or a control relay that stopped switching.

Door won't close properly

Worn hinges or broken door springs, often with a flattened gasket that lets heat escape.

Door locked after self-clean

A door lock motor or switch that failed during the high heat of a self-clean cycle.

Error code or blank display

A faulty control board, a cracked touch pad or an open circuit in the sensor wiring.

We repair single and double wall ovens, the ovens in freestanding and slide-in ranges, and convection and steam-assist models, whether they run on gas or electricity.

Dinner ready to go in and the oven won't heat? Call before 6 PM and a technician can usually come today.

Call Now

How an Oven Repair Visit Works

  1. Tell us the symptoms

    Let us know the brand, gas or electric, and what you see: no heat, the wrong temperature or a code on the display. If there is a code, write it down for us.

  2. We measure, not guess

    The technician checks the elements, igniter and temperature sensor with a meter against the manufacturer's specs, then gives you a firm price.

  3. Tested before we leave

    Once the part is replaced, we heat the oven up and confirm it reaches the set temperature. The repair is covered for 90 days on parts and labour.

What You Get When We Fix Your Oven

An oven that holds the temperature you set, a clear explanation of what failed, and a warranty on the work.

Temperature checked on every job

We don't stop at replacing a part. We run the oven up to temperature and confirm it holds before we pack up.

Appointments until 11 PM

Oven trouble tends to show up at dinner time. Call before 6 PM for a same-day visit, seven days a week.

One price, agreed first

The quote covers the part and the labour, and it doesn't change after you approve it. You pay nothing for the diagnostic if you choose to repair.

Plain explanations

We show you the failed part and explain what went wrong, so you know the oven was repaired and not just reset.

90 days of cover

If the same part fails again within 90 days, we come back and replace it at no charge.

Oven parts on board

Bake and broil elements, hot-surface igniters, temperature sensors and thermal fuses are stocked in the van.

Brands

GE, Whirlpool, Frigidaire, KitchenAid, Bosch, Samsung, LG, Maytag, Electrolux, Jenn-Air and most other oven makers.

Where We Work

Wall ovens in newer Southfork and Tribute homes, range ovens in older houses near downtown Leduc: we fix them all, anywhere in the city. A call before 6 PM usually gets a technician to you the same day.

Neighbourhoods we serve

  • Southfork
  • Meadowview Park
  • Deer Valley
  • Alexandra Park
  • Bridgeport
  • West Haven
  • Suntree
  • Windrose
  • Robinson
  • Corinthia Park
  • Tribute
  • Willow Park

Oven Repair FAQ

Why is my oven not heating up?

On an electric oven, the most common cause is a burnt-out bake element, which often looks blistered or broken. On a gas oven, it is usually a weak igniter that glows but cannot open the gas valve. Both are routine same-day repairs.

Why doesn't my oven temperature match the setting?

Usually a failing temperature sensor or a control that has drifted. If the oven is only slightly off, most models let you adjust the temperature offset in the settings menu. If it is off by more, the sensor or control needs replacing.

My oven door is locked after self-cleaning. What should I do?

Wait until the oven has cooled completely, which can take over an hour, then switch the breaker off for a minute to reset the control. If the door still won't unlock, the lock motor or switch has failed and we can replace it.

Do you repair built-in wall ovens?

Yes. We repair single, double and combination wall ovens. Most have to slide out of the cabinet for access, so we protect the surrounding cabinetry and reinstall the oven level.

How long does an oven repair take?

One to two hours for most jobs, once the part is on hand. Elements, igniters and sensors are usually on the van, so the repair is often finished in one visit.

Why does my oven smell like burning?

Usually food residue or spilled grease burning off the oven floor or the elements. If it smells electrical or you see sparks, a bake element may have shorted: turn the oven off at the breaker and call us.

Get Your Oven Fixed

Share a few details and we'll call back to arrange a visit. If there's a dish waiting to go in, phone us instead for the quickest time.

(368) 210-7033

Open 7 days · 7:00 AM – 11:00 PM

Request a Repair

We'll call you back to confirm a time.